Removing The Pt Unit; Removing The Clamp Bracket - SELVA MARINE Pike 9,9 Service Manual

BRKT

Removing the PT unit

1. Fully tilt the outboard motor up, and then
support it with the tilt stop lever.
WARNING
After tilting up the outboard motor, be
sure to support it with the tilt stop lever.
Otherwise, the outboard motor could sud-
denly lower if the PT unit should lose fluid
pressure.
NOTE:
If the PT unit does not operate, open the
manual valve by turning it counterclockwise,
and then tilt the outboard motor up manually.
2. Remove the plastic tie 1 from the clamp
bracket 2, and then pull out the PT
motor lead 3.
2
3. Remove the bolt 4 and ground lead 5
from the PT unit 6.
4. Remove the bolts 7, washers 8, collars
9 and =, and shaft A.
5. Remove the E-clip B, shaft C, and collar
D, and then remove the upper end of the
tilt rod from the swivel bracket.
7-33
Bracket unit
S6AG7771
3
1
S6AG7770
6. Remove the PT unit 6, and then remove
7
the collar E.
C
D
7
8
9

Removing the clamp bracket

1. Remove the ground lead terminal 1,
self-locking nuts 2, and through tube 3,
and then remove the clamp brackets 4.
2
NOTE:
Be sure to remove the ground lead terminal
1 before removing the self-locking nuts 2.
E
6
B
9
1
0
4
5
A
8
7
S6AU7052
7
S6AU7053
6AU3K11