Removing The Clamp Bracket; Disassembling The Swivel Bracket - SELVA MARINE Pike 9,9 Service Manual

Removing the clamp bracket

1. Remove the tilt pin 1, clamp bracket nut
2, and clamp bracket bolt 3.
2. Remove the tilt stopper plate bolts 4
(swivel bracket side).
3. Remove the self-locking nuts 5 and
plate 6.
4. Remove the through tube 7, tilt lock
lever 8, and collar 9, and then disas-
semble the clamp brackets.
NOTE:
Unhook tilt lock rod 1 0 from the tilt lock
lever 8 when removing the lever.
5. Remove the tilt stopper plate bolts A
(clamp bracket side) and tilt stopper
plates B.
B
A
4
0
8
2
9
5
6
7

Disassembling the swivel bracket

1. Unhook the spring 1 from the tilt support
bar 2. Remove the E-clips 3 from the
tilt lever shaft 4, and then pull out the
shaft and remove the tilt lever 5.
6AU3K11
Clamp bracket and swivel bracket (MT model)
7
A
B
4
5
1
3
S6AU7039
7
4 5
3
6
NOTE:
Unhook tilt lock rod 2 6 from the tilt lever 5
when removing the lever.
2. Remove the E-clip 7 from the stopper
shaft 8, and then pull out the shaft and
remove the tilt support bar 2.
7
3
1
2
S6AU7040
8
2
S6AU7041
7-28
1
2
3
4
5
6
7
8
9