General Torque - SELVA MARINE Pike 9,9 Service Manual

SPEC
Part to be tightened
Upper mount bolt
Engine oil drain bolt
Oil pan bolt
Exhaust manifold bolt
Upper case bolt
Shift rod grommet plate bolt
Self-locking nut
Tilt stopper plate bolt (MT model)
Anode bolt (PT model)
Stopper nut (PT model)
Ground lead bolt (PT model)
PT unit mounting shaft bolt (PT model)
Grease nipple
PT unit (PT model)
PT motor assembly bolt
Reservoir cap
Gear housing bolt
Tilt cylinder end screw
Tilt ram

General torque

This chart specifies tightening torques for
standard fasteners with a standard ISO
thread pitch. Tightening torque specifications
for special components or assemblies are
provided in applicable sections of this man-
ual. To avoid warpage, tighten multi-fastener
assemblies in a crisscross fashion and pro-
gressive stages until the specified torque is
reached. Unless otherwise specified, torque
specifications require clean, dry threads.
Components should be at room temperature.
Nut (A) Bolt (B)
8 mm M5
10 mm M6
12 mm M8
14 mm M10
17 mm M12
2-21
Specification
General torque
specifications
N·m kgf·m ft·lb
5 0.5 3.7
8 0.8 5.9
18 1.8 13.3
36 3.6 26.6
43 4.3 31.7
Thread size
N·m
M6 11
— 24
M8 21
M6 11
M8 18
M6 8
— 19
— 8
M6 8
— 24
M6 8
M8 18
— 3
M5 5
— 5
M5 5
— 45
— 45
Tightening torques
kgf·m ft·lb
1.1 8.1
2.4 17.7
2.1 15.5
1.1 8.1
1.8 13.3
0.8 5.9
1.9 14.0
0.8 5.9
0.8 5.9
2.4 17.7
0.8 5.9
1.8 13.3
0.3 2.2
0.5 3.7
0.5 3.7
0.5 3.7
4.5 33.2
4.5 33.2
6AU3K11
2