Installing The Carburetor; Adjusting The Pilot Screw - SELVA MARINE Pike 9,9 Service Manual

FUEL
3. Install the pilot screw 8, turn it in until it
is lightly seated, and then turn it out the
specified number of turns.
È For Europe
É For Oceania
Pilot screw adjusting tool 9 (for
Europe): 90890-03154
Pilot screw setting: 1 5/8 turns out

Installing the carburetor

1. Install new gaskets 1, the spacer 2, the
carburetor assembly 3, and the intake
silencer 4 using the bolts 5.
NOTE:
Install the spacer 2 with the chamfered side
facing toward the intake manifold.
2. Connect the choke solenoid coupler 6.
(R model)
3. Connect the throttle link rod 7 to the car-
buretor throttle lever and the choke rod
8 to the carburetor choke lever.
4-13
Fuel system
8
È
9
É
8
S6AU4030
1 2 1
NOTE:
• To adjust the throttle link rod, see "Adjust-
ing the throttle link" (3-9).
• Place the choke solenoid coupler 6 under
the junction box 9 after connecting it.
4. Adjust the engine idle speed.
4
NOTE:
If the carburetor has been disassembled and
assembled, adjust the pilot screw, and then
adjust the engine idle speed. See "Adjusting
the pilot screw" (4-13).

Adjusting the pilot screw

1. Adjust the throttle stop screw.
NOTE:
If the carburetor was disassembled, turn the
throttle stop screw in until it contacts the car-
buretor throttle lever, and then turn it in about
1 1/2–1 3/4 turns to tighten it temporarily.
2. Start the engine and warm it up.
3. Attach the special service tool to spark
plug wire #1.
Digital tachometer: 90890-06760
5
4
8
7
3 S6AU4031
6AU3K11
9
6
5
4