SELVA MARINE Pike 9,9 Service Manual page 185

NOTE:
Make sure that the ends b of the outer throt-
tle cables 8 are fitted securely into the holes
in the pivot section of the tiller handle as
shown.
5. Install the tiller handle assembly to the
tiller handle bracket, and then tighten the
nut to the specified torque.
Tiller handle assembly nut:
22 N·m (2.2 kgf·m, 16.2 ft·lb)
6. Install the tiller handle assembly to the
steering bracket, and then tighten the
nuts to the specified torque.
Tiller handle bracket nut:
36 N·m (3.6 kgf·m, 26.6 ft·lb)
7. Connect the throttle cables to the throttle
cam.
NOTE:
• To adjust the throttle cables, see "Adjusting
the throttle cable (H model)" (3-7).
• When adjusting the throttle cables, make
sure that the ends b of the outer cables
are not pulled out of the holes in the pivot
section of the tiller handle.
8. Connect the engine shut-off switch leads
and engine start button lead (E model).
6AU3K11
Tiller handle (short)
7-4
1
2
3
4
5
6
7
8
9