Disassembling The Pt Motor - SELVA MARINE Pike 9,9 Service Manual

BRKT

Disassembling the PT motor

1. Remove the PT unit from the bracket.
NOTE:
To remove the PT unit, see "Removing the
PT unit" (7-33).
2. Fully extend the tilt ram, and then open
the manual valve 1 by turning it counter-
clockwise.
WARNING
Make sure that the tilt ram is fully
extended before removing the PT motor,
otherwise fluid can spurt out from the unit
due to internal pressure.
NOTE:
To prevent the internal PT unit parts from fall-
ing out, lay the PT unit on its side so that the
PT motor is in an upright position before
removing it.
3. Remove the PT motor base bolts 2, and
then remove the PT motor assembly 3
and gasket 4 from the tilt cylinder.
4. Remove the manual valve 5, O-ring 6,
and pin 7.
7-37
Bracket unit
7
3
2
5. Remove the stator 8 and O-ring 9 from
the PT motor base 0.
6. Remove the armature plate screw A,
and then remove the armature assembly
B.
A
2
6
5
4
7
S6AU7062
8
9
S6AU7063
B
S6AU7064
0
6AU3K11