SELVA MARINE Pike 9,9 Service Manual page 232

BRKT
4. Install the tilt piston A.
A
NOTE:
Tighten the tilt piston temporarily, and then
check that the spring 9 is visible through the
oil hole in the piston when the tilt ram assem-
bly is upright.
5. Hold the tilt piston A in a vise using alu-
minum plates on both sides, and then
tighten the tilt ram 6 to the specified
torque.
6
5
A
Power tilt wrench B: 90890-06560
Tilt ram 6:
45 N·m (4.5 kgf·m, 33.2 ft·lb)
6. Install a new O-ring C and the backup
ring D onto the tilt piston.
7-51
Bracket unit
9
S6AU7115
B
S6AU7095
7. Install a new O-ring E to the tilt cylinder
F, and then install the tilt cylinder into
the cylinder G.
F
E
8. Install the PT gear pump, PT motor
assembly, and reservoir cap to the tilt
cylinder.
NOTE:
To install the PT motor assembly and gear
pump assembly, see "Assembling the gear
pump" (7-45).
9. Fill the cylinder with the recommended
PT fluid to about 60%.
Recommended PT fluid:
ATF Dexron II
10. Install the backup ring H and a new O-
ring I to the free piston J, and then
install the free piston into the cylinder G.
C
D
S6AU7096
G
S6AU7097
6AU3K11