Installing The Power Unit - SELVA MARINE Pike 9,9 Service Manual

POWR
11. Install the relief valve E and tighten it to
the specified torque.
E
NOTE:
Apply a thin coat of engine oil to the O-ring of
the relief valve E before installation.
Relief valve E:
8 N·m (0.8 kgf·m, 5.9 ft·lb)
12. Install a new gasket, the thermostat, and
the thermostat cover.
Thermostat cover bolt:
8 N·m (0.8 kgf·m, 5.9 ft·lb)
13. Install a new gasket and the exhaust
cover F, and then tighten the bolts to the
specified torques in 2 stages and in the
sequence shown.
5
F
1
4
Exhaust cover bolt:
1st: 6 N·m (0.6 kgf·m, 4.4 ft·lb)
2nd: 12 N·m (1.2 kgf·m, 8.9 ft·lb)

Installing the power unit

1. Clean the power unit mating surface.
5-51
Power unit
E
S6AU5162
2
3
S6AU5163
2. Install the dowels 1, a new gasket 2,
and the power unit 3, and then tighten
the mounting bolts 4 to the specified
torque.
CAUTION:
Do not reuse the gasket, always replace it
with a new one.
3
1
4
4
Power unit mounting bolt 4:
21 N·m (2.1 kgf·m, 15.5 ft·lb)
3. Install the apron, dipstick, and choke rod.
4. Connect the throttle cables onto the
throttle cam, and then adjust the cables.
(H model)
Connect the throttle cable joint onto the
throttle cam, and then adjust the throttle
cable. (R model)
NOTE:
To adjust the throttle cable(s), see "Adjusting
the throttle cable (H model)" (3-7) or "Adjust-
ing the throttle cable (R model)" (3-8).
5. Connect the flushing hose 5 (for
5
Europe), cooling water hoses 6, and fuel
hose 7.
2
6
BOW
5
17
2
4
3
4
S6AU5164
6AU3K11