SELVA MARINE Pike 9,9 Service Manual page 133

7 6
6. Connect the engine shut-off switch leads,
oil pressure warning indicator leads, and
engine start button leads. (H model)
Connect the 10-pin main harness to the
power unit. (R model)
NOTE:
To connect the leads, see "Electrical compo-
nent and wiring harness routing" (8-1).
7. Install the PT relay and connect the PT
relay lead, PT switch coupler, and PT
switch lead. (PT model)
8. Connect the battery cables, battery lead,
and starter motor lead. (E model)
9. Install the manual starter and driven
sprocket cover, and then connect the
start-in-gear protection cable. (M model)
Install the flywheel magnet cover and
driven sprocket cover. (E model)
NOTE:
To connect the start-in-gear protection cable,
see "Checking the start-in-gear protection (M
model)" (3-11).
6AU3K11
5
S6AU5172
Cylinder block
1
2
3
4
5
6
7
8
9
5-52