Removing The Power Unit - SELVA MARINE Wahoo 15 Service Manual

POWR

Removing the power unit

1. Disconnect the start-in-gear protection
cable, and then remove the sprocket
cover and manual starter. (Manual
starter model)
Remove the sprocket cover and flywheel
magnet cover. (Electric starter model)
NOTE:
Before removing the flywheel magnet cover,
remove the junction box bracket bolts.
(Power tilt model)
2. Remove the retaining plate. Disconnect
the battery cables. (Electric starter
model)
Disconnect the battery cables and 10-pin
main harness coupler. (Remote control
model)
3. Disconnect the flushing hose 1, cooling
water hose 2, and fuel hose 3.
1
4. Remove the junction box cover, and then
remove the plastic ties 4 and clamps 5.
5. Disconnect the engine stop lanyard
switch lead (W) 6. Remove the bolt 7
and engine stop lanyard switch lead (B)
terminal 8. Disconnect the engine start
switch leads (R) 9 and (Br) 0. (Manual
tilt model/Tiller handle model)
Remove the terminal nuts A, and then
disconnect the power tilt motor leads B
and power tilt relay leads C. Disconnect
the power tilt switch coupler D and
power tilt switch leads (R) E. (Power tilt
model)
5-27
Power unit
3
2
S6AG5D00
È
5
5
4
8
É
B C
A
B C 4
4
5
È Manual tilt model/Tiller handle model
É Power tilt model
6. Remove the junction box bracket F.
(Manual tilt model)
Remove the power tilt relay G. (Power
tilt model)
9
F
7
5
4
G
E
6
0
S6AG5D03
S6AG5D04
D
S6AG5D06
6AG3J11