Assembling The Drive Shaft Housing; Installing The Shift Rod, Drive Shaft Housing, And Drive Shaft - SELVA MARINE Pike 9,9 Service Manual

LOWR
2. Install a new bushing 5 into the lower
case.
6
5
7
NOTE:
Install the bushing until its flange is in tight
contact with the lower case.
Bushing installer center bolt 6:
90890-06601
Needle bearing attachment 7:
90890-06616

Assembling the drive shaft housing

1. Install the bushing into the drive shaft
housing.
2
2
Driver rod L3 1: 90890-06652
Bushing attachment 2:
90890-06650
6-13
Lower unit
G
S6AU6041
1
G
S6AU6045
2. Apply grease to new oil seals, and then
install them into the drive shaft housing
to the specified depth.
A A
NOTE:
Install an oil seal halfway into the drive shaft
housing, and then install the other oil seal.
Driver rod L3 3: 90890-06652
Needle bearing attachment 4:
90890-06614
Installation depth a:
6
6.0–6.5 mm (0.24–0.26 in)
Installing the shift rod, drive shaft
housing, and drive shaft
1. Install the forward gear 1 into the lower
case.
2. Install the drive shaft sleeve 2 into the
lower case.
3. Install the shift rod, a new gasket 3, and
the drive shaft housing assembly 4.
NOTE:
Make sure that the projection a on the gas-
ket is toward the starboard side.
4. Install the drive shaft 5, thrust washer
6, pinion 7, and E-clip 8 to the drive
shaft.
3 4
a
4
S6AU6047
6AU3K11
6