Removing The Drive Shaft, Drive Shaft Housing, And Shift Rod; Disassembling The Drive Shaft Housing; Disassembling The Lower Case - SELVA MARINE Pike 9,9 Service Manual

Removing the drive shaft, drive shaft
housing, and shift rod
1. Remove the pinion nut.
2. Remove the pinion, pinion shim(s), and
roller bearing.
3. Remove the drive shaft, and then remove
the drive shaft housing assembly 1, gas-
ket 2, and shift rod 3.
3
1
2
CAUTION:
Be sure to remove the drive shaft before
removing the drive shaft housing assem-
bly from the lower case.
4. Remove the drive shaft sleeve.
5. Pull out the forward gear.
Disassembling the drive shaft
housing
1. Remove the oil seals and bushing.
6AU3K11
Drive shaft and lower case (high thrust model)
6
1
2
S6AU6106

Disassembling the lower case

1. Remove the taper roller bearing outer
race and forward gear shim(s).
S6AU6107
CAUTION:
Do not reuse the bearing, always replace
it with a new one.
NOTE:
Fit the hooks of the puller claw into the slots
a in the lower case.
6
1
2
Driver rod L3 1: 90890-06652
Bushing attachment 2:
90890-06649
1
2
Stopper guide plate 1: 90890-06501
Bearing puller assembly 2:
90890-06535
1
2
3
S6AU6109
4
6
5
6
a
7
S6AU6113
8
9
6-32