SELVA MARINE Pike 9,9 Service Manual page 91

9
8
NOTE:
Hook the end c of the spiral spring 8 onto
the cut-out d in the manual starter cover 9.
6. Install the sheave drum 2 into the man-
ual starter cover 9.
2
NOTE:
• When installing the sheave drum, set the
spiral spring by turning the sheave drum.
• Hook the end e of the spiral spring 8 onto
the cut-out f in the sheave drum 2.
7. Install drive pawl spring 1 =, the drive
plate A, and the screw B.
B
A
A
0
Drive plate screw B:
5 N·m (0.5 kgf·m, 3.7 ft·lb)
6AU3K11
c d
S6AU5032
f
e
9
S6AU5033
S6AU5034
Manual starter (M model)
8. Turn the sheave drum 2 4 turns in the
direction of the arrow shown.
b
4
NOTE:
Hold the starter plunger 4 while turning the
sheave drum as shown.
9. Remove the starter rope from the notch
b, and then fit it into the groove in the
sheave drum.
NOTE:
• Be sure to hold the sheave drum with your
hand so that it turns slowly.
• Allow the spring force to slowly turn the
drum as the starter rope winds around the
drum.
10. Pull the starter handle 7 several times to
check that the sheave drum turns
smoothly and to check the starter rope
for slack. Repeat steps 4–9 if necessary.
4
NOTE:
Hold the starter plunger 4 while pulling the
starter handle 7.
2
S6AU5035
4
7
S6AU5036
5-10
1
2
3
4
5
6
7
8
9