Disassembling The Tilt Cylinder; Checking The Tilt Cylinder And Piston - SELVA MARINE Pike 9,9 Service Manual

BRKT

Disassembling the tilt cylinder

1. Hold the cylinder 1 in a vise using alumi-
num plates a on both sides.
2. Loosen the tilt cylinder end screw, and
then remove the tilt ram assembly.
1
a
WARNING
Make sure that the ram is fully extended
before removing the end screw.
Power tilt wrench 2: 90890-06560
3. Drain the PT fluid.
4. Remove the tilt cylinder 3 and free pis-
ton 4 from the cylinder 1.
4
3
7-49
Bracket unit
2
a
S6AG7215
1
S6AG7250
5. Hold the tilt piston 5 in a vise using alu-
7
minum plates on both sides, and then
remove the tilt piston 5 and tilt cylinder
end screw 6 from the tilt ram 7.
Power tilt wrench 2: 90890-06560
6. Remove the absorber valve 8 from the
tilt piston 5.

Checking the tilt cylinder and piston

1. Check the tilt cylinder 1. Replace if
cracked or scratched.
2. Check the tilt piston 2, free piston 3,
and backup rings 4 and 5. Replace if
cracked or scratched.
3. Check the tilt cylinder end screw 6, dust
seal 7, and backup ring 8. Replace if
cracked or scratched.
7
2
6
5
8
5
S6AU7091
S6AU7090
7
6AU3K11