Assembling The Gear Pump - SELVA MARINE Pike 9,9 Service Manual

BRKT

Assembling the gear pump

CAUTION:
• Do not use a rag when assembling the
PT unit as dust and particles on the PT
unit components can lead to poor per-
formance.
• Do not reuse the O-rings, always replace
them with new ones.
NOTE:
Lubricate the parts with ATF Dexron II during
assembly.
1. Install the drive gear 1, driven gear 2,
balls 3, dowels 4, and main valves 5
to the tilt cylinder 6.
2
5
6
2. Install shuttle piston 1 7 and shuttle pis-
ton 2 8 to the gear pump housing 9,
and then install the housing to the tilt cyl-
inder.
3. Install the gear housing bolts 0, and
then tighten the bolts to the specified
torque.
7
8
7-45
Bracket unit
5
1
4
3
4
S6AG7190
9
0
S6AU7084
7
7
NOTE:
Be sure to install shuttle piston 1 7 and shut-
tle piston 2 8 in the correct positions; the pis-
ton shapes are different.
Gear housing bolt 0:
5 N·m (0.5 kgf·m, 3.7 ft·lb)
4. Install the balls A, valve seals B, man-
ual release pins C, spring D, and filter
E to the gear pump housing.
G
A
A
5. Install the manual valve H and a new O-
ring I to the PT motor base.
6. Install a new gasket J and the PT motor
assembly K to the tilt cylinder, and then
tighten the PT motor assembly bolts L to
the specified torque.
8
E
F
C
D
C
D
G
B
C
F
B
S6AU7085
F G
A
S6AU7086
6AU3K11