Checking The Choke Solenoid (R Model); Charging System (E Model); Checking The Lighting Coil - SELVA MARINE Pike 9,9 Service Manual

6. Connect the yellow/red (Y/R) lead to the
positive penlight battery terminal (1.5 V)
and connect the pink (P) lead to the neg-
ative terminal, and then check that the
warning indicator comes on. Replace the
warning indicator assembly if it does not
come on.
Y/R
+
LED
-
P
CAUTION:
• Only use a penlight battery (1.5 V) when
checking the LED. Other batteries (e.g.,
alkaline batteries or high-voltage batter-
ies) will damage the diode.
• Do not apply more than 1.7 V to the
leads when checking the LED.
NOTE:
A feature of an LED is that it only allows cur-
rent to flow in one direction.
Checking the choke solenoid (R
model)
1. Push the engine start switch at the "ON"
or "START" position, and then check the
operation of the choke solenoid 1.
Check the choke solenoid resistance if it
does not operate.
ON (PUSH)
OFF START (PUSH)
2. Disconnect the choke solenoid coupler.
6AU3K11
Engine electric control system / Charging system (E model)
P
Y/R
+ -
S6AU8051
8
1
S6AU8052
3. Measure the choke solenoid 1 resis-
tance. Replace if out of specification.
1
B
L
Choke solenoid resistance
(reference data):
Blue (L) – Black (B)
4.0 Ω at 20 °C (68 °F)
4. Connect the choke solenoid 1 coupler.

Charging system (E model)

Checking the lighting coil

1. Disconnect the lighting coil connectors.
1
2
3
4
S6AU8058
5
6
8
8
7
8
9
8-36