Checking The Gear Shift Operation (H Model); Checking The Gear Shift Operation (R Model) - SELVA MARINE Pike 9,9 Service Manual

4. Turn the free accel lever 4 counterclock-
wise until it contacts the throttle cam c.
5. Tighten the throttle link stopper screw 1.
6. Turn the throttle grip (H model) or remote
control lever (R model) to the fully open
and fully closed positions and check that
the throttle cam operates smoothly.
NOTE:
After adjusting the throttle link, adjust the
engine idle speed. See "Checking the engine
idle speed" (3-11).
Checking the gear shift operation
(H model)
1. Check that the gear shift operates
smoothly when the shift lever is shifted
from the N position to the F position or R
position. Adjust the shift rod adjusting nut
1 if necessary.
È
N N
R R
F F
É
È H model (short)
É H model (long)
6AU3K11
3
S6AU3028
N N
R R
F F
S6AU3063
1
NOTE:
To adjust the shift rod adjusting nut 1, see
"Installing the lower unit" (6-15) or "Installing
the lower unit" (6-37).
Checking the gear shift operation
(R model)
1. Check that the gear shift operates
smoothly when the remote control lever
is shifted from the N position to the F
position or R position. Adjust the shift
cable length and shift rod adjusting nut if
necessary.
2. Set the remote control lever to the N
position.
3. Loosen the locknut 1, remove the clip
2, and then disconnect the shift cable
joint 3.
3 3
Control system
S6AU3029
3
2
1 1
S6AU3031
3-10
1
2
3
4
5
6
7
8
9