Installing The Water Pump; Installing The Lower Unit - SELVA MARINE Pike 9,9 Service Manual

LOWR

Installing the water pump

1. Install the dowels 1 and outer plate car-
tridge 2.
A A
2. Install the Woodruff key 3 and impeller
4 to the drive shaft.
A A
NOTE:
When installing the impeller 4 onto the drive
shaft, align the groove in the impeller with the
Woodruff key 3.
3. Install the insert cartridge 5 and a new
O-ring 6 into the water pump housing.
b
A A
6-15
Lower unit
1
2
S6AU6053
4
3
S6AG6390
6
a
5
S6AG6570
6
NOTE:
Align the insert cartridge projection a with
the hole b in the water pump housing.
4. Install the water pump housing assembly
7 into the lower case, and then install
the rubber seal 8.
9
LT LT
572
CAUTION:
Do not turn the drive shaft counterclock-
wise, otherwise the water pump impeller
may be damaged.
NOTE:
• Apply grease to the inside of the water
pump housing.
• While turning the drive shaft clockwise,
push down on the water pump housing and
install it.
• Align the projections on the rubber seal 8
with the holes in the water pump housing.
5. Tighten the water pump housing bolts 9
and = to the specified torque.
Water pump housing bolt 9 and =:
18 N·m (1.8 kgf·m, 13.3 ft·lb)

Installing the lower unit

1. Set the shift lever to the R position. (H
model)
Set the remote control lever to the R
position. (R model)
0 0
A A
9
LT LT
S6AU6056
572
6AU3K11
LT LT
572
8
7
6