Removing The Timing Belt And Sprocket - SELVA MARINE Pike 9,9 Service Manual

POWR
Removing the timing belt and
sprocket
1. Remove the flywheel magnet, charge
coil, and lighting coil(s).
NOTE:
See "Replacing the timing belt" (5-3).
" mark a on the driven
2. Align the "1
sprocket 1 with the " " mark b on the
thermostat cover.
NOTE:
Check that the notch c in the drive sprocket
and the " " mark d on the cylinder block are
aligned.
3. Remove the timing belt 2 from the
driven sprocket, and then remove it from
the drive sprocket.
5-21
Power unit
1
a
b
S6AU5054
d
c
S6AU5055
2
5
CAUTION:
Unless directed to do so in the following
instructions,
sprocket or driven sprocket when the tim-
ing belt is not installed. Otherwise the pis-
tons and valves will collide with each
other and be damaged.
4. Align the notch c in the drive sprocket
with the mating surface e of the crank-
case and cylinder block by turning the
crankshaft clockwise approximately 90°
gradually.
5. Hold the driven sprocket using the spe-
cial service tool 3, and then remove the
driven sprocket bolt 4.
4
do not turn the
c
S6AU5056
drive
e
S6AU5057
3
S6AU5059
6AU3K11