Assembling The Propeller Shaft Housing - SELVA MARINE Pike 9,9 Service Manual

LOWR
Assembling the propeller shaft
housing
1. Install a new needle bearing into the pro-
peller shaft housing to the specified
depth a.
a
NOTE:
Install the needle bearing with the manufac-
ture identification mark facing toward the oil
seals (propeller side).
Driver rod L3 1: 90890-06652
Needle bearing attachment 2:
90890-06616
Installation depth a:
0 ± 0.25 mm (0 ± 0.01 in)
2. Apply grease to new oil seals, and then
install them into the propeller shaft hous-
ing to the specified depth b.
6-29
Lower unit
1
G
2
S6AU6099
6
b
NOTE:
Install an oil seal halfway into the propeller
shaft housing, and then install the other oil
seal.
Driver rod L3 3: 90890-06652
Needle bearing attachment 4:
90890-06613
Installation depth b:
4.5–5.0 mm (0.18–0.20 in)
3. Install a new ball bearing into the propel-
ler shaft housing.
NOTE:
Install the ball bearing with the manufacture
identification mark facing toward the reverse
gear.
A A
3
4
S6AU6101
5
6
G
S6AU6103
6AU3K11