Installing The Cylinder Head; Checking The Oil Pump - SELVA MARINE Pike 9,9 Service Manual

POWR
7. Install the rocker arms C, springs D,
and collars E and F into the cylinder
head, and then install the rocker arm
shaft G.
F D F
C
E E
8. Install the oil pump assembly by aligning
the slot c in the oil pump drive shaft with
the camshaft pin H.
d
d c
H
NOTE:
• To disassemble, check, and assemble the
oil pump, see "Checking the oil pump" (5-
37).
• Before installing the oil pump assembly, be
sure to fill it with a small amount of engine
oil through the oil passages d.
5-37
Power unit
D E G
C
E E S6AU5118
S6AU5119
E
S6AU5120
Oil pump assembly bolt:
8 N·m (0.8 kgf·m, 5.9 ft·lb)

Installing the cylinder head

1. Install a new gasket, the dowels, and the
cylinder head, and then tighten the bolts
to the specified torques in the sequence
shown.
5
1
E
4
CAUTION:
Do not reuse the cylinder head gasket,
always replace it with a new one.
NOTE:
• Apply engine oil to the cylinder head bolts
before installation.
• Tighten the bolts to the specified torques in
2 stages.
Cylinder head bolt (M8):
1st: 15 N·m (1.5 kgf·m, 11.1 ft·lb)
2nd: 29 N·m (2.9 kgf·m, 21.4 ft·lb)
Cylinder head bolt (M6):
1st: 6 N·m (0.6 kgf·m, 4.4 ft·lb)
2nd: 12 N·m (1.2 kgf·m, 8.9 ft·lb)

Checking the oil pump

1. Remove the oil pump screws 1 and dis-
assemble the oil pump.
6
9
2
7
3
E
8
S6AU5121
6AU3K11
5
5