Assembling The Drive Shaft Housing - SELVA MARINE Pike 9,9 Service Manual

NOTE:
• Install the needle bearing with the manufac-
ture identification mark b facing upward.
• Install the stopper c onto the driver rod SL
at the installation depth a as shown. Install
the needle bearing until the stopper c con-
tacts the special service tool 5.
Driver rod SL 4: 90890-06602
Bearing depth plate 5: 90890-06603
Needle bearing attachment 6:
90890-06617
Installation depth a:
189.3–189.8 mm (7.45–7.47 in)

Assembling the drive shaft housing

1. Install the bushing into the drive shaft
housing.
2
2
NOTE:
Align a groove a in the bushing with the hole
b in the drive shaft housing.
Driver rod L3 1: 90890-06652
Bushing attachment 2:
90890-06649
2. Apply grease to new oil seals, and then
install them into the drive shaft housing
to the specified depth c.
6AU3K11
Drive shaft and lower case (high thrust model)
6
a
1
b
G
S6AU6123
3
A A
NOTE:
Install an oil seal halfway into the drive shaft
housing, and then install the other oil seal.
Driver rod L3 3: 90890-06652
Needle bearing attachment 4:
90890-06613
Installation depth c:
7.0–8.0 mm (0.28–0.31 in)
c
4
S6AU6125
6-34
1
2
3
4
5
6
7
8
9