Checking The Propeller Shaft Housing; Checking The Propeller Shaft; Assembling The Propeller Shaft Assembly - SELVA MARINE Pike 9,9 Service Manual

4
5
CAUTION:
Do not reuse the bearing, always replace
it with a new one.
Driver rod L3 4: 90890-06652
Needle bearing attachment 5:
90890-06616

Checking the propeller shaft

housing
1. Clean the propeller shaft housing, and
then check it. Replace if cracked or dam-
aged.
2. Check the teeth and dogs of the reverse
gear. Replace the reverse gear if cracked
or worn.
Checking the propeller shaft
1. Check the propeller shaft. Replace if
damaged or worn.
2. Measure the propeller shaft runout.
Replace if above specification.
6AU3K11
5
S6AU6094
6
6
S6AU6095
Propeller shaft housing (high thrust model)
Propeller shaft runout limit:
0.02 mm (0.0008 in)
3. Check the dog clutch, shift plunger, and
cross pin. Replace if cracked or worn.
Assembling the propeller shaft
assembly
1. Insert the spring 1 into the propeller
shaft.
2. Install the dog clutch 2, cross pin 3,
and cross pin ring 4.
NOTE:
Install the dog clutch with the "F" mark facing
toward the forward gear.
3. Install the shift plunger 5.
4
2
5
3
F
4
3
5
6
1
S6AU6096
2
1
S6AU6097
6-28
1
2
3
4
5
6
7
8
9