Adjusting The Throttle Cable - SELVA MARINE Blue Whale 250 EFI Service Manual

Engine idle speed: 600–700 r/min

Adjusting the throttle cable

1. Set the remote control lever to the neu-
tral position and fully close the throttle
lever.
2. Loosen the locknut 1, remove the clip
2, and then disconnect the throttle cable
joint 3.
2 3
1
3. Check that the accelerator lever 4 con-
tacts the fully closed stopper 5.
4
4. Adjust the position of the throttle cable
joint until its hole is aligned with the set
pin on the lever.
6P23H11
The throttle cable joint must be screwed
in a minimum of 8.0 mm (0.31 in) a.
NOTE:
Pull the throttle cable towards the engine to
remove any free play in the cable before
adjusting the position of the throttle cable
joint.
5. Connect the throttle cable joint 3, install
S6P23330
5
S6P23340
Power unit / Control system
a
WARNING
the clip 2, and then tighten the locknut
1.
1
2
S6D53190
3
4
5
3
2
6
1
7
S6P23350
8
9
3-10