Control System; Checking The Engine Idle Speed; Adjusting The Throttle Cable - SELVA MARINE Grey Whale 200 EFI Service Manual

CHK
ADJ
3. Check for water flow at the cooling water
pilot hole. If there is no water flow, check
the cooling water passage inside the out-
board motor.

Control system

Checking the engine idle speed

1. Start the engine and warm it up for 5 min-
utes.
2. Check the engine idle speed using the
Selva genuine tachometer (on-board
meter) or using the YDIS.
NOTE:
To connect and operate the YDIS, see Chap-
ter 9, "YDIS" and the YDIS (Ver. 1.23a or
later) Instruction Manual.
Engine idle speed: 600–700 r/min

Adjusting the throttle cable

1. Set the remote control lever to the neu-
tral position and fully close the throttle
lever.
2. Loosen the locknut 1, remove the clip
2, and then disconnect the throttle cable
joint 3.
3-11
Periodic check and adjustment
S6AL3180
3. Check that the accelerator lever 4 con-
3
tacts the fully closed stopper 5.
4
4. Adjust the position of the throttle cable
joint until its hole is aligned with the set
pin on the accelerator lever 4.
WARNING
The throttle cable joint must be screwed
in a minimum of 8.0 mm (0.31 in) a.
2 3
1
5
a
S6P23330
S6AL3190
S6AL3110
6AL3J11