Installing The Upper Case - SELVA MARINE Wahoo 15 Service Manual

BRKT
4. Apply grease to the grease nipple 7 on
the swivel bracket until it comes out from
the upper bushing a.
A A
NOTE:
To assemble the clamp brackets, see "Install-
ing the clamp bracket" (7-24) or "Installing the
clamp bracket" (7-28).

Installing the upper case

1. Install the upper case assembly 1 to the
clamp bracket.
2. Install the plate and upper mounting nuts
2, and then tighten the upper mounting
nuts to the specified torque.
3. Install the rubber dampers 3 (small), 4
(large), and 5 (front), and then install the
mount housings 6 and ground lead ter-
minal 7 using the mount housing bolts
8 and 9 and the mount housing nuts 0.
NOTE:
• Be sure to remove any oil from the mount
housing bolts 8 and 9.
• Install the ground lead terminal 7 so that it
is within the range a shown.
4. Tighten the mount housing nuts 0 to the
specified torques in 3 stages and in the
sequence shown.
NOTE:
Tighten the mount housing nuts 0 evenly
and in the following order: 1–2–3–4.
5. Install the ground lead terminal A to the
swivel bracket.
7-19
Bracket unit
a
7
S6AG7740
6. Install the ground lead terminal B to the
upper case as shown.
0
0
A
7
C
1
a
2
Upper mounting nut 2:
40 N·m (4.0 kgf·m, 29.5 ft·lb)
Mount housing nut 0:
1st: 15 N·m (1.5 kgf·m, 11.1 ft·lb)
2nd: 28 N·m (2.8 kgf·m, 20.7 ft·lb)
3rd: 32 N·m (3.2 kgf·m, 23.6 ft·lb)
Grease nipple C:
3 N·m (0.3 kgf·m, 2.2 ft·lb)
4
5
6
3
C
3
B
7
LT LT
B
572
8
9
A
4
3
7
A
2
1
4
6
9
8
A
S6AG7670
B
B
S6AG7680J
6AG3J11