BRKT
6. Install the damper B, cover C, and
engine oil drain bolt D, and then tighten
the drain bolt to the specified torque.
Engine oil drain bolt D:
27 N·m (2.7 kgf·m, 19.9 ft·lb)
7. Install the upper mounts E and upper
mount bolts F into the upper case.
8. Install the bracket G, and then tighten
the upper mount bracket bolts H to the
specified torque.
NOTE:
First tighten the center located, when tighten
the upper mount bracket bolts H.
Upper mount bracket bolt H:
54 N·m (5.4 kgf·m, 39.8 ft·lb)
7-19
Bracket unit
9. Install the lower mounts I, lower mount
bolts J, and mount housings K.
NOTE:
Make sure that the ground lead is not dam-
aged.
Installing the upper case
1. Install the washers 1 onto the lower
mounting bolts.
2. Install the upper and lower mounting
bolts into the bracket assembly 2 simul-
taneously.
3. Install the washers 3, upper mounting
nuts 4, and lower mounting nuts 5, and
then tighten them to the specified
torques.
4. Pass the speedometer hose 6 through
the steering arm 7, and then connect it
to the speedometer hose adapter 8.
5. Connect the ground lead 9.
6AL3J11