Installing The Power Unit - SELVA MARINE Blue Whale 250 EFI Service Manual

POWR
7. Install the wiring harness onto the wiring
harness guide with the mark c facing
upward, and then install the clips 8 in
the sequence shown.
8. Fasten the wiring harness using the plas-
tic ties.
8
±
NOTE:
• Be sure to install the wiring harness onto
the wiring harness guide so that the wiring
harness does not come out from the top
edge of the wiring harness guide.
• Be sure to install the wiring harness
between swells d.
9. Install the wiring harness onto the ECM
bracket, and fasten it at the white tape
e.
5-73
Power unit
!
8
c
d
#
S6P25C20
e
S6P25D90E
10. Check that the wiring harness, hoses,
and the other parts do not interfere with
any moving parts.

Installing the power unit

1. Retract the port and starboard top cowl-
ing lock levers.
PORT
STBD
CAUTION:
Make sure that the top cowling lock levers
are retracted and the engine stoppers are
installed before installing the power unit,
otherwise the fuel rails could be dam-
aged.
2. Clean the power unit mating surface, and
install the dowels 1 and a new gasket
2.
3. Install the power unit by installing the
bolts 3 and 4, then tightening them to
the specified torque.
STBD
S6P25360
PORT
S6P25365
6P23H11