Installing The Power Unit - SELVA MARINE Wahoo 15 Service Manual

POWR
12. Install the oil filter, and then tighten it to
the specified torque using a 64 mm (2.5
in) oil filter wrench.
g
NOTE:
• Before installing the oil filter, be sure to
supply engine oil to the oil passage g.
• Apply a thin coat of engine oil to the O-ring
of the new oil filter before installation.
Oil filter wrench: 90890-01426
Oil filter:
18 N·m (1.8 kgf·m, 13.3 ft·lb)
13. Install a new gasket, the thermostat, and
the thermostat cover.
Thermostat cover bolt:
8 N·m (0.8 kgf·m, 5.9 ft·lb)
14. Install a new gasket and the exhaust
cover, and then tighten the bolts to the
specified torques in 2 stages and in the
sequence shown.
4
1
3
7
5-61
Power unit
E
S6AG5A40
5
2
6
S6AG5800
Exhaust cover bolt:
1st: 6 N·m (0.6 kgf·m, 4.4 ft·lb)
2nd: 12 N·m (1.2 kgf·m, 8.9 ft·lb)

Installing the power unit

1. Clean the power unit mating surface, and
then install the dowels 1, a new gasket
2, and the power unit 3.
CAUTION:
Do not reuse the gasket, always replace it
with a new one.
2. Install the mounting bolts 4, and then
tighten them to the specified torque.
B 3 6 8
0 2 1 7
A 4 5 9
BOW
4
NOTE:
Before installing the power unit, be sure to
remove the fuel pump to prevent damaging it.
Power unit mounting bolt:
1st: 27 N·m (2.7 kgf·m, 19.9 ft·lb)
2nd: 27 N·m (2.7 kgf·m, 19.9 ft·lb)
3. Install the apron and dipstick.
4. Install the shift rod cam 5, and then
tighten the bolts 6.
3
2
1
1
LT LT
572
4
4 S6AG5H50
6AG3J11
5