Refitting the gearchange mechanism
Position the gearbox drum selector fork in the centre of the gear rollers.
Position the complete gearchange mechanism (3) in the chain-side crankcase half.
Insert the screws (1) and (2) with the spacer (4).
Temporarily fit gearchange lever (or a service lever) and sprocket and shift to neutral gear.
Set tool (A) part no. 88713.3334 on the gearbox pawl.
Position the tool by inserting the engine pin (25) inside the tool hole; engage tool pin (26) in the gearbox
pawl by pressing with your hand in the indicated point.
In this position first tighten the screw (2) to a torque of 36 Nm (Min. 34 Nm - Max. 38 Nm) and then the
screw (1) to a torque of 16 Nm (Min. 15 Nm - Max. 17 Nm).