Replacing the battery in the active key
Only use 3 Volt CR 2032 lithium ion batteries.
Note
The keys do not need to be reprogrammed after
replacing the battery.
Remove the metal part of the battery.
Use a large sized coin to pry open the shells of the
plastic grip (2€ coin) as shown in fig. 64.
Important
Insert the coil only in the indicated point. Do not
other use other objects inserted in points that are
different than what is shown, as it could damage the
integrated circuit and/or the protective gasket.
Once the plastic shells have been separated, remove
the printed circuit board (1, fig. 65) prying it up
GENTLY with a small flat screwdriver, as shown in
the figure.
104
1
fig. 64
fig. 65