Table of Contents
Advertisement
Replacing the battery in the active key
E
Only use 3 Volt CR 2032 lithium ion batteries.
Note
The keys do not need to be reprogrammed after
replacing the battery.
Remove the metal part of the battery.
Use a large sized coin to pry open the shells of the plastic grip
(2! coin) as shown in fig. 64.
Important
Insert the coil only in the indicated point. Do not other
use other objects inserted in points that are different than
what is shown, as it could damage the integrated circuit and/
or the protective gasket.
Once the plastic shells have been separated, remove the
printed circuit board (1, fig. 65) prying it up GENTLY with a
small flat screwdriver, as shown in the figure.
Important
Insert the point of the flat screwdriver just under the
printed circuit board, being very careful not to damage it. Do
not apply force on the battery or battery holder.
90
1
fig. 64
fig. 65
Advertisement
Table of Contents
