Rear Disc Brake Assembly - Subaru 2009 IMPREZA Service Manual

Hide thumbs Also See for 2009 IMPREZA:

7. Rear Disc Brake Assembly

Do not allow brake fluid to come in contact with

vehicle body. If it does, wash off with water and

wipe away completely.

1) Lift up the vehicle, and then remove the rear

2) Disconnect the brake hose.

3) Remove the caliper mounting bolts.

4) Raise the caliper body, and then move it toward

vehicle center to separate it from the support.

5) Remove the support from housing.

Remove the support only when replacing the rotor

or support. It is not necessary to remove it when

servicing the caliper body assembly.

6) Remove mud and foreign matter from the caliper

body assembly and the support.

Be careful not to allow foreign matter to enter

the brake hose connector.

Rear Disc Brake Assembly

B: INSTALLATION

1) Apply a thin coat of Molykote M7439 (Part No.

K0770YA000) or grease contained in the pad kit to

the support.

2) Install the support to the housing.

Tightening torque:

3) Apply a thin coat of Molykote M7439 (Part No.

K0770YA000) or grease contained in the pad kit to

the pad clip.

4) Apply a thin coat of Molykote AS880N (Part No.

K0777YA010) or the grease contained in the pad

kit to the contact surface between the pad and

66 N·m (6.7 kgf-m, 48.7 ft-lb)