Download Print this page

Subaru 2009 IMPREZA Service Manual page 2621

Hide thumbs Also See for 2009 IMPREZA:

Advertisement

12) Remove the parking brake cable from lever.
(1) Parking brake cable
(2) Lever
13) Remove a retainer from the secondary side
brake shoe. Remove the lever from the brake shoe.
B: INSTALLATION
CAUTION:
Be sure the lining surface is free from brake flu-
id and grease.
1) Apply brake grease to the following locations.
Brake grease:
Brake Grease (Part No. 003602002)
• Six contact surfaces of the brake shoe rim and
back plate gasket
• Contact surface of the brake shoe and the an-
chor pin
• Contact surface of the parking brake lever and
strut
• Contact surface of the brake shoe and adjuster
• Contact surface of the brake shoe and strut
• Contact surface of the lever and brake shoe
2) Install the wave washer and lever to the second-
ary side brake shoe pin, and lock the retainer se-
curely.
3) Install the parking brake cable to the lever.
Parking Brake Assembly (Rear Disc Brake)
PB-00014
4) Install the adjuster and adjusting spring to the
brake shoe.
NOTE:
Install the adjuster with screw section in the ar-
rowed direction shown in the figure below.
(1) Left wheel: front side of vehicle, right wheel:
rear side of vehicle
5) Check that the parking brake cable does not fall
from the cable guide.
6) Install the brake shoes to the back plate with
shoe hold pins, brake shoe springs, and brake
shoe cups.
7) Install the strut and strut spring to the brake
shoes.
NOTE:
Install the strut springs on front side of the vehicle.
8) Install the return springs; first the primary side
(blue) then the secondary side (yellow).
9) Adjust the parking brake. <Ref. to PB-8, AD-
JUSTMENT, Parking Brake Assembly (Rear Disc
Brake).>
10) If new brake shoes are replaced, drive the ve-
hicle to break-in the parking brake lining.
(1) Drive the vehicle at about 35 km/h (22
MPH).
(2) With the parking brake lever button pushed
in, pull the parking brake lever gently.
(3) Drive the vehicle for about 200 m (0.12 mile)
in this condition.
(4) Wait 5 to 10 minutes for the parking brake to
cool down. Repeat steps (1) through (3) again.
(5) After breaking-in, re-adjust the parking
brakes.
PB-7
PARKING BRAKE
PB-00840

Advertisement

loading