Subaru 2009 IMPREZA Service Manual page 2180

11.Clutch Switch
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the instrument panel lower cover.
3) Disconnect the connector of clutch switch.
4) Remove the clutch switches.
B: INSTALLATION
1. CLUTCH SWITCH (CRUISE CONTROL)
1) Move the clevis pin of push rod to left and right,
retain it at the position where it moves smoothly,
and measure the clutch pedal stroke.
Clutch pedal full stroke A:
130 — 135 mm (5.12 — 5.31 in) (Non-turbo
model)
135 — 140 mm (5.31 — 5.51 in) (Turbo model)
Tightening torque:
T:8 N·m (0.8 kgf-m, 5.9 ft-lb)
2) If the clutch pedal stroke is out of specification,
adjust the stroke. <Ref. to CL-24, ADJUSTMENT,
Clutch Pedal.>
3) Connect the clutch switch connector.
Clutch Switch
T
A
CL-00225
2. CLUTCH SWITCH (CLUTCH START)
1) Fully depress the clutch and hold it.
2) Install the clutch pedal plate and clutch switch so
that the gap between them is 3 — 3.5 mm (0.12 —
0.14 in), and then tighten the lock nut.
Tightening torque:
8 N·m (0.8 kgf-m, 5.9 ft-lb)
(A) Plate
(B) Clutch switch
(C) 3 × 3.5 mm (0.12 × 0.14 in)
3) Connect the clutch switch connector.
4) Make sure that engine does not start with clutch
pedal not depressed.
5) Make sure that engine starts with clutch pedal
fully depressed.
C: INSPECTION
1) If the clutch switch (cruise control) does not op-
erate properly (or if it does not stop at the specified
position), replace it with a new part.
Specified position L:
2+1.5 mm (0.079+0.059 in)
L
CL-27
CLUTCH SYSTEM
(A)
(C)
(B)
CL-00104
CL-00231