Subaru 2009 IMPREZA Service Manual page 1899

33) Install the front and center exhaust pipes. (Non-
turbo model) <Ref. to EX(H4SO)-7, INSTALLA-
TION, Front Exhaust Pipe.> <Ref. to EX(H4SO)-9,
INSTALLATION, Center Exhaust Pipe.>
34) Install the center exhaust pipe. (Turbo model)
<Ref. to EX(H4DOTC)-10, INSTALLATION, Center
Exhaust Pipe.>
35) Install the under cover.
36) Lower the vehicle.
37) Install the ATF level gauge.
38) Connect the following connectors and termi-
nals.
• Non-turbo model
(3)
(1)
(1) Rear oxygen sensor connector
(2) Transmission harness connectors
(3) Transmission ground terminal
• Turbo model
(3)
(1)
(1) Rear oxygen sensor connector
(2) Transmission harness connectors
(3) Transmission ground terminal
Automatic Transmission Assembly
AT-04521
(2) (2)
AT-04518
(2)
AT-04580
39) Install the air intake chamber stay. (Non-turbo
model)
Tightening torque:
16 N·m (1.6 kgf-m, 11.8 ft-lb)
40) Install the air intake chamber and intake boot.
(Non-turbo model) <Ref. to IN(H4SO)-7, INSTAL-
LATION, Air Intake Chamber.>
41) Install the intercooler. (Turbo model)
<Ref. to IN(H4DOTC)-13, INSTALLATION, Inter-
cooler.>
42) Connect the ground cable to battery.
43) Fill transmission with ATF through the oil
charge pipe until the fluid level is between the up-
per and lower level on the "COLD" side of the level
gauge. <Ref. to 4AT-27, Automatic Transmission
Fluid.>
44) Lower the vehicle from lift.
45) Check the differential gear oil level. <Ref. to
4AT-29, INSPECTION, Differential Gear Oil.>
46) Check the select lever operation. <Ref. to 4AT-
48, INSPECTION, Inhibitor Switch.>
47) Bleed the air of control valve. (Turbo model)
<Ref. to 4AT-61, PROCEDURE, Air Bleeding of
Control Valve.>
48) Check the ATF level. <Ref. to 4AT-27, IN-
SPECTION, Automatic Transmission Fluid.>
49) Perform learning control promotion. <Ref. to
4AT(diag)-17, FACILITATION OF LEARNING
CONTROL, OPERATION, Subaru Select Moni-
tor.>
50) Perform the road test. <Ref. to 4AT-30, Road
Test.>
4AT-43
AUTOMATIC TRANSMISSION