Subaru 2009 IMPREZA Service Manual page 2177

CLUTCH SYSTEM
4) Remove the clutch pedal and bushings.
(B)
(A)
(A) Clutch pedal
(B) Bushing
5) Remove the stopper from the clutch pedal.
(A)
(A) Stopper
6) Remove the clutch pedal pad. (Non-turbo mod-
el)
D: ASSEMBLY
1) Temporarily assemble the clutch switch, etc. to
pedal bracket.
2) Clean the clutch pedal and brake pedal bushing
holes, apply grease, and install the bushings.
3) Align the holes of the pedal bracket, clutch pedal
and brake pedal, and install the brake pedal return
spring, assist rod, spring and bushing.
NOTE:
Clean the inside of the bushings and apply grease
before installing the spacer.
Clutch Pedal
E: INSPECTION
Move the clutch pedal pads in the lateral direction
with a force of approximately 10 N (1 kgf, 2 lbf) to
check that the clutch pedal deflection is within the
service limit. If it exceeds the service limit, replace
(B)
with new bushings.
Deflection of the clutch pedal:
Service limit
4.0 mm (0.157 in) or less
CL-00602
F: ADJUSTMENT
1) Turn the lock nut until the full stroke of clutch
CL-00603
pedal becomes within the specification.
CAUTION:
When adjusting the full stroke of clutch pedal,
do not turn the clutch switch.
NOTE:
If the lock nut cannot adjust the full stroke of clutch
pedal to the specified value, adjust it by turning the
master cylinder push rod.
Clutch pedal full stroke A:
130 — 135 mm (5.12 — 5.31 in) (non-turbo
model)
135 — 140 mm (5.31 — 5.51 in) (turbo model)
Tightening torque (Clutch switch lock nut):
T: 8 N·m (0.8 kgf-m, 5.9 ft-lb)
CL-24
(A)
(A) Clutch pedal
(B) Brake pedal
A
(B)
CL-00098
T
CL-00225