Subaru 2009 IMPREZA Service Manual page 2654

12) Attach the pinion & valve assembly into the
valve housing.
(1)
(1) Valve housing
(2) Pinion & valve ASSY
13) Using a press, push the outer race of bearing
and press-fit the pinion & valve assembly into hous-
ing.
(1) Pinion & valve ASSY
(2) Bearing
(3) Housing
14) Apply the specified grease to dust cover.
15) Install the dust cover on valve assembly.
CAUTION:
Be sure to install the dust cover to groove of
shaft.
(1)
(1) Dust cover
(2) Groove
Steering Gearbox
(2)
PS-00532
(1)
(2)
(3)
PS-00533
(2)
PS-00534
PS-31
POWER ASSISTED SYSTEM (POWER STEERING)
16) Apply the genuine grease to the pinion gear
and bearing of valve assembly.
17) Install new O-ring to valve assembly.
(1)
(1) O-ring
18) Insert the valve assembly into place while fac-
ing the rack teeth toward pinion.
19) Tighten the bolts alternately to secure the valve
assembly.
Tightening torque:
20 N·m (2.0 kgf-m, 14.8 ft-lb)
CAUTION:
Be sure to alternately tighten the bolts.
20) Apply liquid gasket to 1/3 or more of entire pe-
rimeter of adjusting screw thread.
Liquid gasket:
THREE BOND 1141 (Part No. 004403006)
PS-00165
PS-00535
PS-00143