Subaru 2009 IMPREZA Service Manual page 2141

3) Align the pinion shaft and differential case with
each hole, and drive the straight pin into the holes
from the hypoid driven gear using the ST.
NOTE:
Lock the straight pin after installing.
ST 899904100 STRAIGHT PIN REMOVER
(A)
(C)
(A) Pinion shaft
(B) Differential case
(C) Straight pin
4) Install the roller bearing to differential case.
CAUTION:
Do not apply a load in excess of 10 kN (1 ton, 1.1
US ton, 1.0 Imp ton).
NOTE:
Be careful because the roller bearing outer races
are used as a set.
ST1 499277100 BUSHING 1-2 INSTALLER
ST2 398497701 ADAPTER
ST2
Front Differential Assembly
(B)
MT-00286
ST1
MT-00287
5MT-69
MANUAL TRANSMISSION AND DIFFERENTIAL
5) Install the hypoid driven gear to the differential
case using twelve bolts.
Tightening torque:
T: 62 N·m (6.3 kgf-m, 45.7 ft-lb)
(A)
(B)
(A) Hypoid driven gear
(B) Differential case
2. SIDE RETAINER
1) Install a new oil seal.
ST 18675AA000 DIFFERENTIAL SIDE OIL
SEAL INSTALLER
CAUTION:
• When press-fitting the oil seal to the side re-
tainer, tap with a plastic hammer etc. to press
in.
• Never use a press.
2) Install a new O-ring.
NOTE:
Do not stretch or damage the O-ring.
T
MT-01216
ST
MT-00289
MT-00279