Subaru 2009 IMPREZA Service Manual page 2344

Hide thumbs Also See for 2009 IMPREZA:

DRIVE SHAFT SYSTEM

1) Assemble the front hub unit bearing. <Ref. to

DS-18, ASSEMBLY, Front Hub Unit Bearing.>

2) Place the disc cover between housing and front

hub unit, and tighten the four bolts.

Tightening torque:

65 N·m (6.6 kgf-m, 47.9 ft-lb)

• Do not get closer the tool which charged

magnetism to magnetic encoder.

• Be careful not to damage the magnetic en-

(1) Magnetic encoder

(2) Front hub unit bearing

E: INSPECTION

1) Moving the front tire up and down by hand,

check there is no play in bearing, and check the

wheel rotates smoothly.

2) Inspect the lean of axis direction using a dial

gauge. Replace the bearing if the load range ex-

ceeds the limitation.

Service limit:

Maximum: 0.05 mm (0.0020 in)