Subaru 2009 IMPREZA Service Manual page 1909

4) Fill the 3 locations of the transmission case ex-
cluding the bolt holes with an ample amount of liq-
uid gasket.
Liquid gasket:
THREE BOND 1217B (Part No. K0877YA020)
or equivalent
5) Install the oil pan by equally tightening the bolts.
Tightening torque:
5 N·m (0.5 kgf-m, 3.7 ft-lb)
6) Install the front vehicle speed sensor and torque
converter turbine speed sensor.
Tightening torque:
7 N·m (0.7 kgf-m, 5.2 ft-lb)
7) Connect the connector to the rear vehicle speed
sensor.
8) Install the ATF inlet and outlet pipes.
NOTE:
Use a new copper washer.
Tightening torque:
T1: 25 N·m (2.5 kgf-m, 18.4 ft-lb)
T2: 40 N·m (4.1 kgf-m, 29.5 ft-lb)
T3: 45 N·m (4.6 kgf-m, 33.2 ft-lb)
T1
9) Install the transmission rear crossmember bolt.
Tightening torque:
70 N·m (7.1 kgf-m, 51.6 ft-lb)
10) Install the propeller shaft. <Ref. to DS-11, IN-
STALLATION, Propeller Shaft.>
Front Vehicle Speed Sensor
AT-04837
T2
T3
AT-04676
4AT-53
AUTOMATIC TRANSMISSION
11) Install the heat shield cover.
12) Install the front, center and rear exhaust pipes,
and the muffler. (Non-turbo model)
<Ref. to EX(H4SO)-7, INSTALLATION, Front Ex-
haust Pipe.> <Ref. to EX(H4SO)-9, INSTALLA-
TION, Center Exhaust Pipe.> <Ref. to EX(H4SO)-
10, INSTALLATION, Rear Exhaust Pipe.> <Ref. to
EX(H4SO)-12, INSTALLATION, Muffler.>
13) Install the center, rear exhaust pipes and the
muffler. (Turbo model) <Ref. to EX(H4DOTC)-10,
INSTALLATION, Center Exhaust Pipe.> <Ref. to
EX(H4DOTC)-13, INSTALLATION, Rear Exhaust
Pipe.> <Ref. to EX(H4DOTC)-15, INSTALLATION,
Muffler.>
14) Lower the vehicle.
15) Install the transmission harness connector to
the stay.
16) Install the pitching stopper. <Ref. to 4AT-44,
INSTALLATION, Transmission Mounting System.>
17) Install the air intake chamber. (Non-turbo mod-
el) <Ref. to IN(H4SO)-7, INSTALLATION, Air In-
take Chamber.>
18) Install the intercooler. (Turbo model)
<Ref. to IN(H4DOTC)-13, INSTALLATION, Inter-
cooler.>
19) Fill with the same amount of ATF as drained.
<Ref. to 4AT-27, Automatic Transmission Fluid.>
20) Bleed the air of control valve.
<Ref. to 4AT-61, PROCEDURE, Air Bleeding of
Control Valve.>
21) Inspect the level of ATF. <Ref. to 4AT-27, IN-
SPECTION, Automatic Transmission Fluid.>
22) Perform learning control promotion. <Ref. to
4AT(diag)-17, FACILITATION OF LEARNING
CONTROL, OPERATION, Subaru Select Moni-
tor.>
AT-04522