Subaru 2009 IMPREZA Service Manual page 2125

4) Using ST1 and ST2, remove the rest of the
parts.
NOTE:
• When replacing the sleeve and hub, replace
them as a set.
• Do not disassemble the sleeve and hub; the
aligning position is pre-matched.
• If it is necessary to disassemble, mark the en-
gaging points on the splines beforehand.
ST1 899864100 REMOVER
ST2 899714110 REMOVER
ST2
(A) Press
Main Shaft Assembly for Single-Range
(A)
ST1
MT-00190
MANUAL TRANSMISSION AND DIFFERENTIAL
D: ASSEMBLY
1) When the sleeve and hub assemblies have been
disassembled, reassemble by aligning the align-
ment marks.
NOTE:
Position the open ends of the spring 120° apart.
(A)
(B)
(A) 3rd-4th sleeve & hub ASSY
(B) 3rd gear side
2) Install the 3rd drive gear, outer baulk ring, syn-
chro cone, inner baulk ring, sleeve and hub assem-
bly for the 3rd needle bearing, on the transmission
main shaft.
NOTE:
Align the groove in baulk ring with the shifting in-
sert.
(A) 3rd needle bearing
(B) 3rd drive gear
(C) Inner baulk ring
(D) Synchro cone
(E) Outer baulk ring
(F) Sleeve & hub ASSY
5MT-53
MT-01852
(A) (D) (E)
(F)
(B) (C)
MT-01318