Subaru 2009 IMPREZA Service Manual page 1896

AUTOMATIC TRANSMISSION
B: INSTALLATION
1) Replace the differential side oil seal with a new
part. <Ref. to 4AT-47, Differential Side Retainer Oil
Seal.>
NOTE:
When a new oil seal has been installed, replace-
ment is not required.
2) Install the rear cushion rubber to the transmis-
sion assembly.
Tightening torque:
40 N·m (4.1 kgf-m, 29.5 ft-lb)
3) Attach the ST to the converter case.
ST 498277200 STOPPER SET
4) Install the transmission onto the engine.
(1) Lift up the transmission gradually using
transmission jack.
(2) Insert the engine side stud bolt into the
transmission bolt hole.
(3) While raising the transmission jack gradual-
ly, turn the screw of engine support, then tilt the
engine forward and connect.
Automatic Transmission Assembly
ST
AT-03633
AT-04857
4AT-40
5) Install the transmission rear crossmember.
Tightening torque:
T1: 35 N·m (3.6 kgf-m, 25.8 ft-lb)
T2: 70 N·m (7.1 kgf-m, 51.6 ft-lb)
T 2
6) Remove the transmission jack.
7) Tighten the bolts and nuts which hold the lower
side of transmission to the engine.
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
8) Install the clutch housing cover bolts.
9) Lower the vehicle.
10) Connect the engine and transmission.
(1) Remove the ST from converter case.
NOTE:
When removing the ST, be careful not to drop it into
converter case.
(2) Install the starter. <Ref. to SC(H4SO)-7, IN-
STALLATION, Starter.>
(3) Tighten the bolts which hold the upper side
of the transmission to the engine.
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
T 1
T 2
AT-03698
AT-00108
AT-00106