Subaru 2009 IMPREZA Service Manual page 2480

VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS)
5. PARAMETER SELECTION
CAUTION:
• Subaru Select Monitor is required for param-
eter selection.
• This function can be used for the replace-
ment part of VDCCM&H/U and VDCCM.
NOTE:
• When the VDCCM is replaced with a replace-
ment part, be sure to perform the parameter selec-
tion/registration to the VDCCM using this function.
• To confirm the applied model, refer to the "model
number plate" attached on the vehicle. <Ref. to ID-
2, IDENTIFICATION, Identification.>
• When the applied model is entered wrong, re-en-
try is possible.
• When the registration has not been performed,
the DTC code "Parameter selection error" is detect-
ed together with the ABS/EBD/VDC warning light il-
lumination.
1) Connect the Subaru Select Monitor.
2) On «Main Menu» display, select {Each System
Check}.
3) On «System Selection Menu» display, select
{Brake Control System}.
4) Click the [OK] button after {VDC} is displayed.
5) On «Brake Control Diagnosis» display, select
{Selection of Parameter}.
6) Check the applied model indicated in the "Model
number plate". <Ref. to ID-2, IDENTIFICATION,
Identification.>
7) Enter the applied model of 7-digit alphanumeric
characters and press the [Enter] key.
8) When the confirmation screen indicating the ve-
hicle information appears, check that the correct
applied model and grade are displayed and click
the [OK] button.
NOTE:
When the displayed applied model and grade are
different from those of the vehicle, perform registra-
tion operations again after clicking the [OK] button.
9) Execute Clear Memory after parameter selec-
tion and registration operations because the DTC
for "Parameter selection error" is memorized.
Subaru Select Monitor
6. PARAMETER CHECK
NOTE:
The parameter data registered in the VDCCM is
shown on the display.
1) Connect the Subaru Select Monitor.
2) On «Main Menu» display, select {Each System
Check}.
3) On «System Selection Menu» display, select
{Brake Control System}.
4) Click the [OK] button after {VDC} is displayed.
5) On «Brake Control Diagnosis» display, select
{Confirm on parameter}.
6) On the {Confirm on parameter} display screen,
check that the applied model and grade of the tar-
get vehicle are included, and click the [OK] button.
7) If the applied model and grade of the target ve-
hicle are not included on the {Confirm on parame-
ter} display screen, perform parameter selection
and registration. <Ref. to VDC(diag)-18, PARAME-
TER SELECTION, OPERATION, Subaru Select
Monitor.>
VDC(diag)-18