Subaru 2009 IMPREZA Service Manual page 1986

Hide thumbs Also See for 2009 IMPREZA:

AUTOMATIC TRANSMISSION

2) Insert the range select lever, and tighten the

Tightening torque:

6 N·m (0.6 kgf-m, 4.4 ft-lb)

3) Insert the manual plate and parking rod.

(B) Range select lever

(D) Parking rod

4) Insert a new spring pin into the manual plate.

5) Install the oil pan and the control valve assem-

bly. <Ref. to 4AT-59, INSTALLATION, Control

Valve Body.>

6) Turn over the transmission case to its original

7) Install the pitching stopper bracket.

Tightening torque:

41 N·m (4.2 kgf-m, 30.2 ft-lb)

8) Install and adjust the inhibitor switch. <Ref. to

4AT-48, Inhibitor Switch.>

Transmission Control Device

9) Insert the inhibitor switch connector and trans-

mission harness connector onto the stay.

(A) Transmission harness connectors

(B) Inhibitor switch connector

10) Install the air breather hose. <Ref. to 4AT-67,

INSTALLATION, Air Breather Hose.>

11) Insert the input shaft while rotating it lightly by

hand, and then check the amount of protrusion.

Normal protrusion A:

50 — 55 mm (1.97 — 2.17 in)

A Measured value

12) Install the torque converter clutch assembly.

<Ref. to 4AT-69, INSTALLATION, Torque Convert-

er Clutch Assembly.>

13) Install the transmission assembly to the vehi-

cle. <Ref. to 4AT-40, INSTALLATION, Automatic

Transmission Assembly.>

C: INSPECTION

Make sure that the manual lever and detent spring

are not worn or otherwise damaged.