Subaru 2009 IMPREZA Service Manual page 1939

Hide thumbs Also See for 2009 IMPREZA:

30.Converter Case

1) Remove the transmission assembly from the ve-

hicle. <Ref. to 4AT-36, REMOVAL, Automatic

Transmission Assembly.>

2) Pull out the torque converter clutch assembly.

<Ref. to 4AT-69, REMOVAL, Torque Converter

Clutch Assembly.>

3) Remove the input shaft.

4) Lift up the lever on the rear side of transmission

harness connector, and then disconnect it from the

5) Disconnect the inhibitor switch connector from

(A) Transmission harness connectors

(B) Inhibitor switch connector

6) Remove the air breather hose. <Ref. to 4AT-67,

REMOVAL, Air Breather Hose.>

7) Remove the oil charge pipe. <Ref. to 4AT-68,

REMOVAL, Oil Charge Pipe.>

8) Remove the ATF inlet and outlet pipes. <Ref. to

4AT-64, REMOVAL, ATF Cooler Pipe and Hose.>

Converter Case

9) Remove the converter case alignment bolt, and

then separate the transmission case and converter

case by lightly tapping with a plastic hammer.

• Be careful not to damage the oil seal and bush-

ing in the converter case with the oil pump cover.

• Be careful not to loosen the rubber seal.

10) Remove the seal pipe.

11) Remove the front differential assembly. <Ref.

to 4AT-98, REMOVAL, Front Differential Assem-

12) Remove the oil seal from converter case.

AUTOMATIC TRANSMISSION

(A) Seal pipe