Subaru 2009 IMPREZA Service Manual page 1893

11) Separate the torque converter clutch from the
drive plate.
CAUTION:
• Be careful not to damage the mounting bolts.
• Be careful not to drop bolts into the converter
case.
(1) Remove the V-belt covers.
(2) Remove the service hole plug.
(3) Remove the bolts which hold the torque
converter clutch assembly to the drive plate.
(4) Place the wrench on the crank pulley bolt,
and remove all the bolts while rotating the crank
pulley a little bit at a time.
(5) Make sure the torque converter moves free-
ly by rotating with finger through the starter in-
stallation hole.
12) Attach the ST to the converter case.
ST 498277200 STOPPER SET
13) Remove the ATF level gauge.
NOTE:
Plug the opening to prevent entry of foreign parti-
cles into the transmission fluid.
14) Remove the pitching stopper bracket.
Automatic Transmission Assembly
AT-00102
ST
AT-03633
AT-04521
4AT-37
AUTOMATIC TRANSMISSION
15) Disconnect the engine harness, then remove
the harness connector from the engine harness
bracket. (Non-turbo model)
16) Remove the engine harness bracket. (Non-tur-
bo model)
17) Remove the engine hanger. (Turbo model)
18) Set the ST.
ST 41099AC000 ENGINE SUPPORT ASSY
ST
19) Lift up the vehicle.
20) Remove the under cover.
21) Remove the front, center and rear exhaust
pipes and the muffler. (Non-turbo model)
<Ref. to EX(H4SO)-6, REMOVAL, Front Exhaust
Pipe.> <Ref. to EX(H4SO)-9, REMOVAL, Center
Exhaust Pipe.> <Ref. to EX(H4SO)-10, REMOV-
AL, Rear Exhaust Pipe.> <Ref. to EX(H4SO)-12,
REMOVAL, Muffler.>
22) Remove the center and rear exhaust pipes and
the muffler. (Turbo model)
<Ref. to EX(H4DOTC)-8, REMOVAL, Center Ex-
haust Pipe.> <Ref. to EX(H4DOTC)-13, REMOV-
AL, Rear Exhaust Pipe.> <Ref. to EX(H4DOTC)-
15, REMOVAL, Muffler.>
AT-04581
AT-04582
AT-02167