Subaru 2009 IMPREZA Service Manual page 2126

MANUAL TRANSMISSION AND DIFFERENTIAL
3) Install the 4th needle bearing race onto trans-
mission main shaft using ST1, ST2 and press.
CAUTION:
Do not apply a load in excess of 10 kN (1 ton, 1.1
US ton, 1.0 Imp ton).
ST1 899714110 REMOVER
ST2 499877000 RACE 4-5 INSTALLER
ST2
(A)
ST1
(A) 4th needle bearing race
4) Install the baulk ring, needle bearing, 4th drive
gear and 4th gear thrust washer to the transmission
main shaft.
NOTE:
Align the baulk ring and hub & sleeve assembly
with the key groove.
(B)
(A) Groove
(B) Face this surface to the 4th gear side.
Main Shaft Assembly for Single-Range
MT-00192
(A)
MT-00193
5MT-54
5) Using ST1, ST2 and a press, press-fit the ball
bearing (non-turbo model) or double-row tapered
roller bearing (turbo model) into the rear section of
transmission main shaft.
CAUTION:
Do not apply a load in excess of 10 kN (1 ton, 1.1
US ton, 1.0 Imp ton).
ST1 899714110 REMOVER
ST2 499877000 RACE 4-5 INSTALLER
6) Using the ST1 and ST2, install the 5th gear
thrust washer (non-turbo model) and 5th needle
bearing race onto the rear section of transmission
main shaft.
CAUTION:
Do not apply a load in excess of 10 kN (1 ton, 1.1
US ton, 1.0 Imp ton).
NOTE:
Make sure the thrust washer is facing the correct
direction.
ST1 899714110 REMOVER
ST2 499877000 RACE 4-5 INSTALLER
(A) Face this surface to the 5th gear side.
ST2
ST1
MT-00194
(A)
MT-00195