Subaru 2009 IMPREZA Service Manual page 2121

14.Transmission Case
A: REMOVAL
1) Remove the manual transmission assembly
from the vehicle. <Ref. to 5MT-21, REMOVAL,
Manual Transmission Assembly.>
2) Remove the clutch release lever. <Ref. to CL-
14, REMOVAL, Release Bearing and Lever.>
3) Remove the transfer case together with the ex-
tension case assembly. <Ref. to 5MT-36, REMOV-
AL, Transfer Case
Assembly.>
4) Remove the bearing mounting bolt.
5) Remove the main shaft rear plate.
(A)
(A) Main shaft rear plate
6) Remove the coupling bolts and nuts, and sepa-
rate the transmission case into the right and left
case.
Transmission Case
and Extension Case
MT-01514
MT-01515
MT-00160
5MT-49
MANUAL TRANSMISSION AND DIFFERENTIAL
7) Remove the drive pinion shaft assembly from
the left side of the transmission case.
NOTE:
Use a hammer handle, etc. to remove if too tight.
( B )
(A) Main shaft ASSY for single-range
(B) Drive pinion shaft ASSY
8) Remove the main shaft assembly for single-
range.
9) Remove the front differential assembly.
NOTE:
• Do not confuse the right and left roller bearing
outer races.
• Be careful not to damage the oil seal of retainer.
( A )
MT-00161
MT-00162