Subaru 2009 IMPREZA Service Manual page 2176

10.Clutch Pedal
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the steering column. <Ref. to PS-15,
REMOVAL, Tilt Steering Column.>
3) Disconnect the connector from the stop light
switch and clutch switch.
4) Remove the snap pins from clevis pins which se-
cure the lever to the push rod and operating rod.
5) Pull out the clevis pins which secures the lever to
the push rod and operating rod.
(A)
(D)
(C)
(A) Operating rod
(B) Push rod
(C) Snap pin
(D) Clevis pin
6) Remove the air intake chamber. (Non-turbo
model) <Ref. to IN(H4SO)-7, REMOVAL, Air Intake
Chamber.>
7) Remove the intercooler. (Turbo model)
<Ref. to IN(H4DOTC)-13, REMOVAL, Intercool-
er.>
8) Remove the nut which secures the clutch master
cylinder.
9) Remove the bolts and nuts which secure the
brake pedal and clutch pedal, and remove the ped-
al assembly.
Clutch Pedal
B: INSTALLATION
1) Install in the reverse order of removal.
Tightening torque:
CAUTION:
Always use a new clevis pin.
2) Adjust the clutch pedal after installation. <Ref. to
CL-24, ADJUSTMENT, Clutch Pedal.>
3) Adjust the clutch switch (clutch start). <Ref. to
CL-28, ADJUSTMENT, Clutch Switch.>
C: DISASSEMBLY
1) Remove the clutch switches.
2) Remove the clip, assist spring, rod and bushing.
(D)
(C)
(B)
CL-00618
3) Remove the spring pin and lever.
CL-00093
CL-23
18 N·m (1.8 kgf-m, 13.3 ft-lb)
(D)
(A)
(E)
(C)
(D)
(D)
(B)
(E)
(C)
(A) Clip
(B) Assist spring
(C) Assist rod
(D) Bushing
(E) Clevis pin
(A) Pin
(B) Lever
CLUTCH SYSTEM
CL-00354
(A)
(B)
CL-00095